Plumber in Spring Glen, UT

Yes, and the fix is very different. Low pressure at just one faucet almost always means a clogged aerator (the small mesh screen at the faucet tip) or a partially closed isolation valve under the sink - both are quick, inexpensive fixes. Low water pressure throughout the entire house is a more significant issue: it can indicate a failing pressure reducing valve (PRV), significant internal corrosion narrowing your main supply line, a partially closed main shutoff valve, or in older homes, widespread galvanized pipe deterioration. We'll check pressure at multiple points to diagnose which situation you're dealing with.

Not always. We offer two main approaches: traditional open-cut excavation (which is sometimes the best option for severely deteriorated lines or collapsed pipes), and trenchless methods that don't require major digging. The most common trenchless technique is pipe lining - we thread a flexible liner coated with epoxy through your existing sewer pipe, inflate it, and cure it in place, creating a new pipe inside the old one. This saves your landscaping, driveway, and the cost of restoration. We always perform a camera inspection first to determine which approach is right for your specific situation.

Common warning signs: your water meter keeps moving even when every faucet is off, you notice warm or wet spots on your concrete floor, you hear running water when the house is completely quiet, your water bill jumped significantly for no clear reason, or you smell mold without seeing any visible source. Slab leaks are serious - water leaking under your foundation can cause significant structural damage over time. We use electronic acoustic sensors and thermal imaging cameras to pinpoint the exact location before any work is done, so the repair is surgical rather than destructive.

First: find your main water shutoff valve and turn it off completely. This is usually located near the water meter, in the basement, or in a utility closet. Once the water is off, the damage stops. Then call us - we answer 24/7. While you wait, try to mop up standing water and move valuables away from the wet area. Do not turn the water back on until a plumber has identified and repaired the break. Most burst supply line repairs can be completed in 1–2 hours once we arrive.